Statements in which the resource exists as a subject.
PredicateObject
rdf:type
lifeskim:mentions
pubmed:issue
2
pubmed:dateCreated
1997-5-28
pubmed:abstractText
The interpenetrating polymer networks (INPs) of polyurethane (PU) and 2-hydroxyethyl methacrylate (MEHA)-terminated polyurethane (HPU) were prepared by solution polymerization. PU prepolymer was synthesized from 4,4-diphenyl methane diisocyanate (MDI) and poly(propylene oxide) glycol (PPG). HPU prepolymer was synthesized from MDI, poly(tetramethylene oxide) glycol and HEMA. Dynamic mechanical analysis showed that the resultant IPN membranes have good compatibility between their constituents. As the HPU content increased, the tensile strength of the IPNs first increased and then decreased. For the highest tensile strength, the optimum HPU content was about 25 wt %. The value of surface tension of IPNs varied from 44.4 to 50.5 dyne/cm, and polarity ranged from 0.59 to 0.91. The relative index of platelet adhesion (RIPA) of the IPN membranes was measured by the dynamic thrombosis test at constant shaking speed and temperature. By the criteria of this test, the IPN membranes with HPU content of about 25 wt% to the minimum platelet adhesion. When measured by the angular dependent ESCA technique on the surface of IPN samples, the variation in the RIPA correlated to the change in the surface soft segment to hard segment ratio. Higher HPU content resulted in more migration of soft segments toward the surface. The platelet adhesion was observed to be minimized when the surface O/N ratio was around 12.
pubmed:language
eng
pubmed:journal
pubmed:citationSubset
IM
pubmed:chemical
pubmed:status
MEDLINE
pubmed:month
Feb
pubmed:issn
0021-9304
pubmed:author
pubmed:issnType
Print
pubmed:volume
34
pubmed:owner
NLM
pubmed:authorsComplete
Y
pubmed:pagination
261-8
pubmed:dateRevised
2006-11-15
pubmed:meshHeading
pubmed:year
1997
pubmed:articleTitle
2-hydroxyethyl methacrylate-terminated polyurethane/polyurethane interpenetrating polymer networks.
pubmed:affiliation
Department of Chemical Engineering, National Taiwan Institute of Technology, Taipei.
pubmed:publicationType
Journal Article, Research Support, Non-U.S. Gov't