Linked Life Data

8934405

Source:http://linkedlifedata.com/resource/pubmed/id/8934405

Statements in which the resource exists as a subject.
PredicateObject
rdf:type
lifeskim:mentions
pubmed:issue
4-5
pubmed:dateCreated
1997-2-18
pubmed:abstractText
Reconstruction of the rheumatoid metacarpophalangeal (MCP) joint is generally achieved by means of implantation of a hinged silastic prosthesis. These implants reduce the pain in joint and restore some degree of mobility. However, they are prone to failure after a relatively short life-span. In this study, two popular designs of MCP implant, the Swanson and the Sutter, were compared by means of three-dimensional finite element analysis. The aim was to examine how the differing geometry effected their relative stiffness as replacement joints, and whether they were inherently prone to high stress concentrations during flexion. Although the Swanson design implant exhibited relatively greater resistance to flexion, both designs showed regions of high stress concentration and it was noted that neither was without its limitations. The use of the finite element technique was found to be an excellent way to provide preliminary design evaluation information, allowing further evolution before clinical trials.
pubmed:language
eng
pubmed:journal
pubmed:citationSubset
IM
pubmed:status
MEDLINE
pubmed:issn
0309-1902
pubmed:author
pubmed:issnType
Print
pubmed:volume
20
pubmed:owner
NLM
pubmed:authorsComplete
Y
pubmed:pagination
145-50
pubmed:dateRevised
2006-11-15
pubmed:meshHeading
pubmed:articleTitle
An examination of one-piece metacarpophalangeal joint implants using finite element analysis.
pubmed:affiliation
Department of Medical Physics and Clinical Engineering, University of Sheffield, Royal Hallamshire Hospital, UK.
pubmed:publicationType
Journal Article, Research Support, Non-U.S. Gov't